The Reconn-Deck Bar Roof Top Tent Bracket Kit (part RTTRDB) is the hardware that connects a rooftop tent to your Rhino-Rack Reconn-Deck Bars. It is not a tent and not a load bar — it's the four-bracket bridge between the two. Each kit ships with four stainless steel brackets, a black finish to match the bars, all mounting hardware, and a PDF install guide.
The brackets carry pre-cut mounting holes, so there is no drilling the brackets themselves. You bolt one bracket at each corner between the Reconn-Deck Bars and the underside of your tent base, then torque to spec. The four-point layout also lets you slide the tent fore or aft along the bars to balance the load against whatever you're hauling in the bed below. Install is rated intermediate; budget about an hour with a second set of hands to lift the tent.
Fitment follows your Reconn-Deck Bars, not the vehicle — any rig running Reconn-Deck Bars can use the kit. It suits most hard-base rooftop tents that bolt down through floor channels; confirm your tent's channels accept the included hardware before install. The bracket inherits the dynamic load rating of your bars and vehicle, so the system rating, not the kit, sets your ceiling.
